Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING RECEIVER

TIRE PRESSURE WARNING RECEIVER > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING RECEIVER ASSEMBLY


C128501E01
  1. Attach the clip and install the bolt with the receiver.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the connector.



2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



3. INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH


    B079224E02
  1. Attach the 6 claws and 2 clips to install the side panel.

  1. Install the clip, screw and 2 bolts.



4. INSTALL REAR DECK TRIM COVER


    B076395E02
  1. Attach the 4 claws to install the trim cover.



5. INSTALL REAR FLOOR NO. 1 BOARD


    B132619E01
  1. Attach the 5 clips to install the floor board.

  1. Install the 2 clips, 2 bolts and 2 rope hooks.



6. INSTALL DECK FLOOR BOX LH


7. INSTALL DECK FLOOR BOX REAR


8. INSTALL REAR FLOOR NO. 4 BOARD


9. INSTALL REAR FLOOR NO. 3 BOARD


10. INSTALL REAR FLOOR NO. 2 BOARD


11. INSTALL TONNEAU COVER ASSEMBLY


12. INSTALL BACK DOOR WEATHERSTRIP


13. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY RH
  1. Connect the floor anchor with the bolt.

    Torque:
    42 N*m{ 430 kgf*cm , 31 ft.*lbf }



14. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP RH


15. INSTALL REAR SIDE SEATBACK FRAME LH


    B132620
  1. Attach the claw to install the frame.

  1. Install the bolt.



16. INSTALL REAR SIDE SEATBACK FRAME RH

HINT:
Use the same procedures described for the LH side.



17. INSTALL REAR DOOR SCUFF PLATE RH

HINT:
Use the same procedures described for the LH side.



18. INSTALL REAR SEAT CUSHION ASSEMBLY

NOTICE:
When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.



    B132601E01
  1. Attach the seat cushion's rear hook to the center hinge.

  1. Insert the inner belts through the slits on the seat cushion.



    B132602
  1. Attach the seat cushion's 2 front hooks to the vehicle body.

  1. Confirm that the seat cushion is firmly installed.



19. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
  1. When the warning light is illuminated or the battery has been disconnected and reconnected, pressing the power switch may not start the system on the first try. If so, press the power switch again.
  2. With the power switch's power mode changed to ON (IG), disconnect the battery. If the key is not in the key slot during reconnection, DTC B2799 may be output.
  3. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



20. REGISTER TRANSMITTER ID
  1. Register the transmitter ID (Click here).



21. INSPECT TIRE PRESSURE WARNING SYSTEM
  1. Inspect the tire pressure warning system (Click here).