Home › SUSPENSION & AXLE › TIRE AND WHEEL › TIRE PRESSURE WARNING ECU

TIRE PRESSURE WARNING ECU > INSTALLATION

for Preparation Click here



1. INSTALL TIRE PRESSURE WARNING ECU


C128498E01
  1. Install the ECU with the bolt.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }

  1. Connect the connector.



2. INSTALL MULTI-DISPLAY ASSEMBLY
  1. Install the multi-display .



3. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY


B074049E03
  1. Attach the 2 claws and 4 clips to install the instrument panel register.



4. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY


B074048E03
  1. Attach the 6 clips to install the instrument panel register.



5. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY


B074047E03
  1. Connect the connector.

  1. Attach the claw and 5 clips to install the instrument panel register.



6. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY UPPER


B074046E03
  1. Connect the connector.

  1. Attach the 3 claws and 4 clips to install the instrument panel finish panel.



7. INSTALL INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LOWER


B074045E03
  1. Connect the connectors.

  1. Attach the 4 claws and 5 clips to install the instrument panel finish panel.

  1. Connect the hood lock control cable.

  1. Install the 2 screws.



8. INSTALL NO. 1 INSTRUMENT PANEL REGISTER ASSEMBLY


B074044E03
  1. Attach the 2 claws and 4 clips to install the instrument panel register.



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
  1. When the warning light is illuminated or the battery has been disconnected and reconnected, pressing the power switch may not start the system on the first try. If so, press the power switch again.
  2. With the power switch's power mode changed to ON (IG), disconnect the battery. If the key is not in the key slot during reconnection, DTC B2799 may be output.
  3. When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



10. REGISTER TRANSMITTER ID
  1. Register the transmitter ID (Click here).



11. INSPECT TIRE PRESSURE WARNING SYSTEM
  1. Inspect the tire pressure warning system (Click here).