CRUISE CONTROL MAIN SWITCH > INSTALLATION |
| 1. INSTALL CRUISE CONTROL MAIN SWITCH |
Install the switch with the 2 screws.
Connect the connector.
| 2. INSTALL STEERING WHEEL ASSEMBLY |
Align the matchmarks on the steering wheel and steering main shaft.
Install the steering wheel with the set nut.
| 3. INSTALL STEERING PAD ASSEMBLY |
![]() |
Support the steering pad with one hand as shown in the illustration.
Connect the 2 airbag connectors.
Connect the horn connector.
Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.
Using a T30 "TORX" socket, install the 2 screws.
| 4. INSTALL NO. 2 STEERING WHEEL COVER LOWER |
| 5. INSTALL NO. 3 STEERING WHEEL COVER LOWER |
| 6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 7. PERFORM INITIALIZATION |
Perform initialization (Click here).
| 8. CHECK SRS WARNING LIGHT |
Check the SRS warning light (Click here).