Home › ENGINE › 1NZ-FXE STARTING › KEY SLOT

KEY SLOT > INSPECTION

for Preparation Click here



1. INSPECT KEY SLOT


B080048E02
  1. Remove the key slot (Click here).

  1. Measure the resistance of the key slot.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 (KSW2) - 2 (COM)
    Key is in key slot
    10 kΩ or higher

    If the result is not as specified, replace the key slot.



    E074066E06
  1. Inspect the key slot illumination.

    1. Connect the battery positive (+) lead from the battery to terminal 2 and the battery negative (-) lead to terminal 6, then check that the illumination comes on.

      OK:
      Illumination comes on.