FRONT DOOR > ADJUSTMENT |
![]() |
| 1. ADJUST FRONT DOOR SUB-ASSEMBLY |
Disconnect the negative (-) terminal cable from the battery.
![]() |
Using SST, loosen the body side's hinge bolts and adjust the door's position.
Tighten the body side's hinge bolts after the adjustment.
![]() |
Loosen the door side's hinge bolts and adjust the door's position.
Tighten the door side's hinge bolts after the adjustment.
![]() |
Using a T40 "torx" wrench, adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
Tighten the striker mounting screws after the adjustment.
Connect the negative (-) terminal cable to the battery.
Check which systems need to be initialized and perform initialization (Click here).
Check the SRS warning light (Click here).