AIR FUEL RATIO SENSOR > ON-VEHICLE INSPECTION |
| 1. CHECK AIR FUEL RATIO COMPENSATION SYSTEM |
![]() |
Inspect the voltage.
Turn the power switch ON (IG).
Using a voltmeter, measure the voltage between the ECM terminals.
| Tester Connection | Specified Condition |
| E5-23 (A1A+) - E5-28 (E1) | 3.0 to 3.6 V |
| E5-22 (A1A-) - E5-28 (E1) | 2.7 to 3.3 V |
Check the output waveform.
Set the vehicle to inspection mode (Click here).
Connect Techstream to the DLC3.
Turn the power switch ON (READY).
Turn Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Data List /AFS B1 S1, O2S B1 S2.
Warm up the air fuel ratio sensor for approximately 2 minutes at 2500 rpm of the engine speed.
![]() |
Maintain the engine speed at 2500 rpm, then check that the waveform of "AFS B1 S1" is output as illustrated.
Check that "O2S B1 S2" fluctuates between 0 and 1 V with the engine speed at 2500 rpm.