Home › BODY ELECTRICAL › AUDIO / VISUAL › RADIO ANTENNA HOLDER

RADIO ANTENNA HOLDER > INSTALLATION

for Preparation Click here



1. INSTALL ANTENNA (CORD / POLE SEPARATE TYPE) HOLDER ASSEMBLY


    I038873E01
  1. Install the antenna holder assembly on the roof and align the antenna cord with the antenna nut cutout.

  1. Tighten the antenna holder assembly with the antenna nut.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

  1. Attach the clamp.

  1. Connect the connector.



2. INSTALL ROOF HEADLINING ASSEMBLY
  1. Install the roof headlining (Click here).



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.