Home › BODY ELECTRICAL › AUDIO / VISUAL › STEERING PAD SWITCH

STEERING PAD SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL STEERING PAD SWITCH LH


I038856E02
  1. Connect the connector.

  1. Attach the 2 claws to install the steering pad switch.



2. INSTALL STEERING PAD SWITCH RH


I038855E02
  1. Connect the connector.

  1. Attach the 2 claws to install the steering pad switch.



3. INSTALL STEERING PAD ASSEMBLY


H043738E03
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.

  1. Using a T30 "TORX" socket, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



4. INSTALL NO. 2 STEERING WHEEL COVER LOWER


5. INSTALL NO. 3 STEERING WHEEL COVER LOWER


6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


7. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.



8. INSPECT STEERING PAD ASSEMBLY
  1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.

  1. Check that the horn sounds.



9. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).