Home › HYBRID SYSTEM › HYBRID TRANSMISSION / TRANSAXLE › OIL PUMP DRIVE SHAFT

OIL PUMP DRIVE SHAFT > INSTALLATION

for Preparation Click here



1. INSTALL OIL PUMP DRIVE SHAFT


    C069318E01
  1. Apply ATF WS to the oil pump drive shaft and install it to the hybrid vehicle transaxle.

    HINT:
    Use genuine ATF WS.



2. INSTALL OIL PUMP DRIVEN ROTOR


    C099329E02
  1. Apply ATF WS to the oil pump driven rotor and install it to the hybrid vehicle transaxle.

    HINT:
    Use genuine ATF WS.



3. INSTALL TRANSAXLE OIL PUMP DRIVE ROTOR


    C099329E03
  1. Apply ATF WS to the oil pump drive rotor and install it to the hybrid vehicle transaxle.

    HINT:
    Use genuine ATF WS.



4. INSTALL TRANSMISSION OIL PUMP COVER SUB-ASSEMBLY


    G031019E01
  1. Install a new O-ring to the hybrid transaxle.

    NOTICE:
    Do not twist the O-ring when installing it.



    C069315E01
  1. Apply adhesive to the first 2 or 3 threads of the bolt end.

    Adhesive:
    Toyota Genuine Adhesive 1344,
    Three Bond 1344 or equivalent

    NOTICE:
    Clean and degrease the bolts and bolt holes.

  1. Install the oil pump cover with the 5 bolts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }



5. INSTALL FRONT WHEEL


6. ADD TRANSAXLE OIL

Fluid type:
Toyota genuine ATF WS
Standard capacity:
3.8 liters (4.0 US qts, 3.3 Imp. qts)



7. INSPECT TRANSAXLE OIL
  1. Inspect transaxle oil (Click here).



8. INSTALL ENGINE UNDER COVER LH