Home › BODY › INTERIOR › FUEL LID LOCK CONTROL

FUEL LID LOCK CONTROL > INSTALLATION

for Preparation Click here



1. INSTALL FUEL FILLER OPENING LID LOCK RETAINER


    B073320E03
  1. Install the lock retainer and turn it clockwise as shown in the illustration.



2. INSTALL FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY


    B073318E05
  1. Attach the claw and install the cable to the lock retainer.



  1. Connect the cable from the clamps at the location shown in the illustration.


    B075120E02



3. INSTALL FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
  1. Connect the cable to the lever.



    B074573E01
  1. Install the lever with the screw.



4. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH


    B073592E03
  1. Attach the 6 clips and claw to install the inner garnish.



5. INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH


    B073591E02
  1. Attach the 7 claws and 3 clips to install the side panel.

  1. Install the clip, screw and 2 bolts.



6. INSTALL CENTER PILLAR LOWER GARNISH LH


    B073589E03
  1. Attach the 2 claws and 2 clips to the lower garnish.



7. INSTALL REAR DOOR SCUFF PLATE LH


    B073587E02
  1. Attach the 6 claws and clip to install the scuff plate.



8. INSTALL FRONT DOOR SCUFF PLATE LH


    B073586E02
  1. Attach the 8 claws and 2 clips to install the scuff plate.



9. INSTALL REAR SIDE SEATBACK ASSEMBLY LH
  1. Install the side seatback with the bolt.



10. INSTALL REAR SEAT CUSHION ASSEMBLY

NOTICE:
When installing the seat cushion, make sure the seat belt buckle is not under the seat cushion.



    B132601E01
  1. Attach the seat cushion's rear hook to the center hinge.

  1. Insert the inner belts through the slits on the seat cushion.



    B132602
  1. Attach the seat cushion's 2 front hooks to the vehicle body.

  1. Confirm that the seat cushion is firmly installed.



11. INSTALL FRONT SEAT ASSEMBLY LH
  1. Install the seat (Click here).



12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


13. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.