When the washer nozzle is clogged with wax, etc., do not use metal objects such as a safety pin to clean the washer nozzle hole. Be sure to use a soft resin brush, etc.
- NOTICE:
- For Initialization:
- When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
System Name
| See page
|
Power Window Control System
|
Click here
|
- NOTICE:
- When the warning light is illuminated or the battery has been disconnected and reconnected, pressing the power switch may not start the system on the first try. If so, press the power switch again.
- With the power switch's power mode changed to ON (IG), disconnect the battery. If the key is not in the key slot during reconnection, DTC B2799 may be output.