Home › BODY ELECTRICAL › WIPER AND WASHER › WIPER SWITCH

WIPER SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL WIPER AND WASHER SWITCH


I038895E03
  1. Attach the claw to install the wiper switch.

  1. Connect the connector.



2. INSTALL STEERING COLUMN COVER
  1. Engage the 4 claws to install the steering column upper cover and steering column lower cover.

    HINT:
    Fully tilt down the steering column when installing the steering column upper cover and fully tilt it up when installing the steering column cover.



3. INSTALL TILT LEVER BRACKET
  1. Install the tilt level bracket with the 2 screws.

    Torque:
    2.0 N*m{ 20 kgf*cm , 18 in.*lbf }



4. INSTALL SPIRAL CABLE SUB-ASSEMBLY
  1. Check that the front wheels are facing straight ahead.

  1. Set the turn signal switch to the neutral position.

    NOTICE:
    Make sure that the turn signal switch is in the neutral position, as the pin of the turn signal switch may be snapped.

  1. Install the spiral cable.

    NOTICE:
    When replacing the spiral cable with a new one, remove the lock pin before installing the steering wheel.

  1. Connect the connector to the spiral cable.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.



5. INSTALL STEERING WHEEL ASSEMBLY
  1. Align the matchmarks on the steering wheel and steering main shaft.

  1. Install the steering wheel with the set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



6. INSTALL NO. 2 STEERING WHEEL COVER LOWER


7. REMOVE NO. 3 STEERING WHEEL COVER LOWER


8. INSTALL STEERING PAD ASSEMBLY


H043738E03
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 airbag connectors.

    NOTICE:
    When handling the airbag connector, do not damage the airbag wire harness.

  1. Connect the horn connector.

  1. Install the steering pad after confirming that the circumference grooves of the screws are caught on the screw case.

  1. Using a T30 "TORX" socket, install the 2 screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



9. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


10. INSPECT STEERING PAD ASSEMBLY
  1. Check for cuts, cracks or discoloration on the steering pad outer surface and in the grooved portion.

  1. Check that the horn sounds.



11. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).



12. PERFORM INITIALIZATION
  1. Perform initialization (Click here).

    NOTICE:
    Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.