DTC P0607 Control Module Performance |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0607 | ECM (1-trip detection logic) | ECM |
| Related DTC | P0607: ECM CPU malfunction |
| Required sensors/Components | ECM |
| Frequency of Operation | Continuous |
| Duration | Within 1 second |
| MIL Operation | Immediate |
| Sequence of Operation | None |
| Monitor will run whenever this DTC is not present | None |
| Either of the following conditions is met: | Condition A or B |
| A. All of the following conditions are met: | Conditions (a), (b) and (c) |
| (a) CPU reset | 1 time or more |
| (b) Leaned TP - learned APP | 0.4 V or more |
| (c) Throttle actuator | OFF |
| B. CPU reset | 2 times or more |
| 1.CHECK WHETHER DTC OUTPUT RECURS (DTC P0607) |
Connect Techstream to the DLC3.
Turn the power switch ON (IG) and turn the tester on.
Clear the DTCs (Click here).
Turn the power switch OFF and turn the tester off.
Disconnect the battery negative terminal and wait for 1 minute.
Connect the battery negative terminal.
Turn the power switch ON (IG) and turn the tester on.
Select the following menu items: Powertrain / Engine and ECT / Trouble Code.
Read the DTCs.
| Display (DTC output) | Proceed to |
| P0607 | A |
| No output | B |
|
| ||||
| A | ||
| ||