Home › ENGINE › 1NZ-FXE ENGINE CONTROL SYSTEM › SFI SYSTEM

DTC    P0657    Actuator Supply Voltage Circuit / Open

for Preparation Click here


DESCRIPTION

The ECM monitors the output voltage to the throttle actuator. This self-check ensures that the ECM is functioning properly. The output voltage usually is 0 V when the power switch is turned off. If the output voltage is higher than 7 V when the power switch is turned off, the ECM will illuminate the MIL and set a DTC when the power switch is turned ON (IG).

DTC
DTC Setting Condition
Trouble Area
P0657
Throttle actuator power supply error
(1-trip detection logic)
ECM

MONITOR STRATEGY


Related DTC
P0657: ETCS power supply
Required sensors/Components (main)
ECM
Required sensors/Components (sub)
Throttle actuator
Frequency of Operation
Once per driving cycle
Duration
Within 1 second
MIL Operation
Immediate
Sequence of Operation
None

TYPICAL ENABLING CONDITIONS


Monitor will run whenever this DTC is not present
None
Power switch
From ON (IG) to OFF

TYPICAL MALFUNCTION THRESHOLDS


Throttle actuator power supply
7 V or more

INSPECTION PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS (DTC P0657)
  1. Connect Techstream to the DLC3.

  1. Turn the power switch ON (IG) and turn the tester on.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off and turn the tester off.

  1. Disconnect the battery negative terminal and wait for 1 minute.

  1. Connect the battery negative terminal.

  1. Turn the power switch ON (IG) for 10 seconds.

  1. Turn the power switch off.

  1. Turn the power switch ON (IG) and turn the tester on.

  1. Select the following menu items: Powertrain / Engine and ECT / Trouble Code.

  1. Read the DTCs.

    Result:
    Display (DTC output)
    Proceed to
    P0657
    A
    No output
    B



B
CHECK FOR INTERMITTENT PROBLEMS
A

REPLACE ECM