Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › 2011.12–2017.06
BM2170E _V1 General _057058 INTRODUCTION _0278232 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY  


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.

·

Ensure that the headlight assembly is not damaged.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER (for Halogen Headlight)


a.
E247281

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E247282

Install the upper headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT PROTECTOR RETAINER (for Halogen Headlight)


a.
E247285

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E247286

Install the lower headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT BRACKET (for Halogen Headlight)


a.
E247283

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight bracket against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E247284

Install the lower headlight bracket with the 3 screws.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER (for LED Headlight)


a.
E247288

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E247289

Install the upper headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT PROTECTOR RETAINER (for LED Headlight)


a.
E247292

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E247293

Install the lower headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT BRACKET (for LED Headlight)


a.
E247290

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight bracket against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E247291

Install the lower headlight bracket with the 3 screws.