With the cowl top side upper panel removed.
REMOVAL
| Symbol meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut with Disc Sander etc. |
|
Cut and Join Location |
|
Cut Location for Supply Parts |
*1 is reused.
INSTALLATION
| Symbol meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
|
Cut and Join Location |
|
Fillet Weld |
|
Butt Weld |
|
Body Sealer |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
If the entire supply part is not needed, remove the part of the supply part that is needed.
Before installing a new part, apply body sealer.
Apply body sealer in an even, continuous bead.
Before temporarily installing the new parts, weld the rocker reinforce sub-assembly outer, front body pillar sub-assembly inner and front pillar reinforcement sub-assembly lower with the standard number of welding points.
When welding *1, make a hole on a new part for plug welding and weld the panel with the panel.
After welding the rocker reinforce sub-assembly outer, front body pillar sub-assembly inner and front pillar reinforcement sub-assembly lower to the vehicle side, install the front body pillar outer and *2.
After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.