Home › Vehicle Exterior › BODY PANEL › REAR DOOR OUTER PANEL
BM2170E _01 Vehicle Exterior _057059 BODY WELD POINT _0278246 REAR DOOR OUTER PANEL F

BODY WELD POINT  REAR DOOR OUTER PANEL  CUT AND JOIN REPLACEMENT SECTIONS  


K104266

REMOVAL


Symbol meaning
K108827

Cut and Join Location


REMOVAL POINT
1.

After grinding off the hemming location, remove the outer panel.


K104246E02
3.969,6.01 5.25,6.25 1.281,0.24 10 false Hemming Location 3.719,8.313 4.573,8.531 0.854,0.219 10 false Disc Sander

INSTALLATION


Symbol meaning
K108831

Butt Weld
K108833

Spot MIG Weld
K108834

Body Sealer


INSTALLATION POINT
1.

Before temporarily installing the new parts, apply body sealer to the reinforcement, side impact protection beam and backside of the new parts.

NOTICE:

Do not close the drain hole.


HINT:

Apply sealer evenly about 10 mm (0.39 in.) from the flange and 3 mm (0.12 in.) in diameter on the outer panel and apply just enough sealer for the reinforcement and side impact protection beam to make contact.


2.

Bend the flange hem about 30° with a hammer and dolly. Then, fasten tightly with a hemming tool.

HINT:
·

Perform hemming in three steps, being careful not to warp the panel.

·

If a hemming tool cannot be used, hem with a hammer and dolly.



3.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K135730E01
2.021,3.979 2.021,3.698 false 5.406,6.031 5.406,5.344 5.406,5.344 5.583,5.344 false 5.74,6.198 6.01,6.01 6.01,6.01 6.104,6.01 false 5.906,6.76 6.135,6.958 6.135,6.958 6.25,6.958 false 5.49,8.781 5.604,9.083 5.604,9.083 5.729,9.083 false 4.552,2.094 5.146,2.333 0.594,0.24 10 false 10 (0.39) 5.917,3.708 6.667,3.958 0.75,0.25 10 false Drain Hole. 1.177,3.99 3.125,4.219 1.948,0.229 10 false REAR DOOR PANEL OUTER 5.625,5.26 6.063,5.51 0.438,0.25 10 false Dolly 6.146,5.917 6.885,6.156 0.74,0.24 10 false Cloth Tape 6.292,6.865 6.896,7.115 0.604,0.25 10 false Hammer 4.76,6.583 5.031,6.802 0.271,0.219 10 false 30° 5.771,8.99 6.76,9.24 0.99,0.25 10 false Hemming Tool 0.333,9.406 0.948,9.635 0.615,0.229 10 false mm (in.)