With the Quarter Panel and body lower back panel removed.
REMOVAL
| Symbol meaning | |
|---|---|
|
Remove Weld Points |
|
Remove Weld Points |
|
Cut with Disc Sander etc. |
Cut the quarter panel and fold it upward as shown in *1. Then cut through the welded area of the center floor pan and quarter panel extension upper, and remove the back door opening trough.
INSTALLATION
| Symbol meaning | |
|---|---|
|
Plug Weld |
|
Plug Weld |
|
Plug Weld |
|
Butt Weld |
Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.
Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimensions)
When welding *1, make a hole on a new part for plug welding and weld the panel with the panel behind completely.
Before temporarily installing the new parts, weld the back door stay retainer and back door opening trough with the standard number of welding points.
After welding, apply body sealer to the corresponding parts. (See the painting / coating)
After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.