Home › Vehicle Exterior › BODY PANEL › REAR FLOOR PAN › 2011.12–2017.06
BM2170E _01 Vehicle Exterior _057059 BODY WELD POINT _0278255 REAR FLOOR PAN F

BODY WELD POINT  REAR FLOOR PAN  ASSEMBLY REPLACEMENT  


K104290

With the floor side rail front panel removed.


REMOVAL


Symbol meaning
K108818

Remove Weld Points


K135449

INSTALLATION


Symbol meaning
K108823

Plug Weld
K108830

Fillet Weld


INSTALLATION POINT
1.

Before temporarily installing the new parts, weld the rear floor pan, spare wheel clamp bracket, actuator cover bracket No.3 and weld bolts with the standard number of welding points.

2.

After welding, apply body sealer and undercoating to the corresponding parts. (See the painting / coating)

3.

After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.


K135450E01
2.813,4.292 3,4.292 3,4.292 3.208,3.792 false 4.438,4.063 4.271,4.063 4.271,4.063 3.729,2.99 false 1.76,6.646 2.396,6.646 false 2.385,7.292 1.958,7.292 1.958,7.292 1.958,6.646 false 3.979,8.25 3.792,8.25 3.792,8.25 3.094,7.104 false 1.802,0.927 3.823,1.167 2.021,0.24 12 false Upper Face: 1.802,5.021 3.823,5.26 2.021,0.24 12 false Lower Face: 4.469,3.958 6.792,4.156 2.323,0.198 10 false SPARE WHEEL CLAMP BRACKET 1.563,4.177 2.917,4.375 1.354,0.198 10 false REAR FLOOR PAN 0.573,6.531 1.375,6.729 0.802,0.198 10 false Weld Bolts 4.01,8.146 6.427,8.333 2.417,0.188 10 false ACTUATOR COVER BRACKET NO.3

K135451