Home › Vehicle Exterior › BODY DIMENSIONS › UNDER BODY
BM2170E _01 Vehicle Exterior _057060 BODY DIMENSIONS _0278267 UNDER BODY F

BODY DIMENSIONS  UNDER BODY  TWO-DIMENSIONAL DISTANCE  


HINT:
·

Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.

·

In cases in which only one dimension is given, left and right are symmetrical.


·

For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).



Measuring Point Name
Symbol Name Hole Diameter
mm (in.)
A, a Bumper Reinforcement Installation Nut M10 (0.39)
B, b Radiator Lower Support Standard Hole φ18 (0.71)
C, c Front Side Inner Member Standard Hole φ18 (0.71)
D, d Front Suspension Member Installation Nut M12 (0.47)
E, e Front Spring Support Standard Hole φ11 (0.43)
F, f Front Suspension Member Installation Nut M14 (0.55)
G, g Torque Front Box Standard Hole φ25 (0.98)
H, h Front Floor Center Panel Standard Hole φ18 (0.71)
J, j Front Side Inner Rear Member Standard Hole φ18 (0.71)
K, k Front Floor Center Panel Standard Hole φ18 (0.71)
L, l Floor Side Inner Rear Member Standard Hole φ18 (0.71)
M, m Trailing Arm Installation Hole φ15 (0.59)
N, n Rear Floor Side Front Member Standard Hole φ18 (0.71)
O, o Rear Spring Plate Standard Hole φ18 (0.71)
P, p Rear Shock Absorber Installation Hole φ18 (0.71)
Q, q Rear Floor Side Front Member Standard Hole φ18 (0.71)

Wheel Base
Wheel Base 2550 mm (100.39 in.)

K135748E01
1.833,0.792 2.146,0.99 0.313,0.198 10 false LH 3.292,0.792 3.604,0.99 0.313,0.198 10 false RH 2.563,0.063 2.875,0.26 0.313,0.198 10 false FR 0.156,8.49 0.469,8.688 0.313,0.198 10 false mm 0.156,8.646 0.479,8.865 0.323,0.219 10 false (in.)

K135749E01
0.865,4.01 2.271,4.229 1.406,0.219 10 false Imaginary Datum Line 0.573,5.271 2.677,5.49 2.104,0.219 10 false Height from Imaginary Datum Line 4.563,5.271 5.958,5.469 1.396,0.198 10 false Imaginary Datum Line 0.156,8.479 0.469,8.677 0.313,0.198 10 false mm 0.156,8.625 0.448,8.865 0.292,0.24 10 false (in.) 0.948,1.094 1.26,1.292 0.313,0.198 10 false FR