In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).
| Symbol | Name | Hole Diameter
mm (in.) |
|---|---|---|
| A, a | Front Fender No.2 Side Apron Standard Hole | φ8 (0.31) |
| B, b | Front Spring Support Standard Hole | φ11 (0.43) |
| C, c | Hood Hinge Installation Nut | M8 (0.31) |
| D | Cowl Top Panel Center Mark | - |
| E, e | Front Side Inner Member Standard Hole | φ15 (0.59) |
| F, f | Front Side Inner Member Standard Hole | φ10 (0.39) |
| G, g | Radiator Support Upper Installation Nut | M6 (0.24) |
| H, h | Bumper Reinforcement Installation Nut | M10 (0.39) |
| J, j | Radiator Support Standard Hole | φ10 (0.39) |
| K, k | Front Fender Mounting Bracket Standard Hole | φ10 (0.39) |
| L | Hood Lock Brace Installation Nut | M6 (0.24) |
| M, m | Bumper Cover Installation Hole | M6 (0.24) |