Home › General › INTRODUCTION › WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS › from 2017.06
BM2170E _V1 General _057058 INTRODUCTION _0278232 WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS F

INTRODUCTION  WHEN REMOVING,INSTALLING,REPAIRING OR REPLACING PARTS  REPAIR PROCEDURE OF HEADLIGHT ASSEMBLY  


HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure listed below is for the LH side.

·

If the installation area of the headlight assembly is damaged, use the supply retainer for low-cost repair.

·

Ensure that the headlight assembly is not damaged.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER (for Halogen Headlight)


a.
E372208

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E372962

Install the upper headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT PROTECTOR RETAINER (for Halogen Headlight)


a.
E372963

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E372964

Install the lower headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT BRACKET (for Halogen Headlight)


a.
E372965

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight bracket against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E372966

Install the lower headlight bracket with the 2 screws.



INSTALL UPPER HEADLIGHT PROTECTOR RETAINER (for LED Headlight)


a.
E372967

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E372968

Install the upper headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT PROTECTOR RETAINER (for LED Headlight)


a.
E372969

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E372970

Install the lower headlight protector retainer with the 2 screws.



INSTALL LOWER HEADLIGHT BRACKET (for LED Headlight)


a.
E372971

Cut off the part shaded in the illustration and sand smooth with sandpaper.

NOTICE:

After cutting off the part, place the lower headlight bracket against the bosses and gradually file away the old bracket if it interferes with the installation of the supply retainer.



b.
E372972

Install the lower headlight bracket with the 2 screws.