SYSTEM CONTROL
The power window control system has the following system control:
| Function | Outline |
|---|---|
| Manual Up-and-down | This function causes the window to close or open while driver side's switch of the power window regulator master switch assembly is being pulled halfway up or pushed halfway down, or while except driver side's switch of the power window regulator master switch or the power window regulator switch assembly is being pulled up or pushed down. The window stops as soon as the switch is released. |
| One-touch Auto Up-and-down (Driver's Door) | The one-touch auto up-and-down function enables the window to be fully closed or opened at a touch of the power window regulator master switch assembly. |
| Jam Protection (Driver's Door) | The jam protection function automatically stops the power window and moves it downward if a foreign object gets jammed in the window during one-touch auto up operation or manual up operation. |
| Remote Control | The up-and-down operations of the front passenger's door window and the rear door windows can be controlled by operating the power window regulator master switch assembly. |
| Window Lock | Power window operation of the front passenger's door window and the rear door windows is disabled when the window lock switch is pressed. |
| Key-off Operation | The key-off operation function makes it possible to operate the power windows for approximately 43 seconds after the ignition switch is turned to ACC or off, if the front doors are not opened. |
The power window ECU built into the driver's door power window regulator motor assembly stores the initial position of its door window. The initial position is not cleared even if battery terminals, fuses or the power window motor connector is disconnected. However, after removing or reinstalling window components, or replacing the power window regulator sub-assembly or power window regulator motor assembly, the stored initial position data must be cleared and/or initialization must be performed. For details, refer to the Repair Manual.
Jam Protection Function
The jam protection function automatically stops the power window and moves it downward if a foreign object gets jammed in the door window during one-touch auto up operation or manual up operation.
If the window position from the full close position (amount it is open) is less than approximately 200 mm (7.9 in.) after the window has moved downward by approximately 125 mm (4.9 in.) or for approximately 2.5 seconds, the jam protection further moves the power window downward until the amount of open reaches approximately 200 mm (7.9 in.) or approximately 5 seconds have elapsed. However, if the power window is fully opened before the power window moves downward by approximately 125 mm (4.9 in.), this function stops.
Switch signal inputs for manual up-and-down and one-touch auto up-and-down operations are prohibited while the jam protection is moving the power window downward. The switch signal inputs are permitted after the jam protection operation is completed.
The magnet and Hall IC in the power window motor are used to enable power window jam protection.
| *1 | Hall IC | *2 | Worm Gear |
| *3 | Magnet (for Rotation Detection) | - | - |
The Hall IC converts the changes in the magnetic flux that occur through the rotation of the magnet into pulse signals and outputs them to the power window ECU.
To control the jam protection function, the ECU determines the amount of movement and jamming of the window glass based on the pulse signals from the Hall IC.
FAIL-SAFE
When the power window ECU detects that there is an abnormality in the Hall IC which detects the position, speed and direction of the window, the ECU enters fail-safe mode.