FUNCTION
Fuel Returnless System
This system is used to reduce evaporative emissions. As shown below, by integrating the fuel pressure regulator assembly, fuel suction filter and fuel pump with the fuel suction with pump and gauge tube assembly, it is possible to discontinue the return of fuel from the engine area and prevent temperature rise inside the fuel tank assembly.
| *1 | Fuel Delivery Pipe | *2 | Fuel Injector Assembly |
| *3 | Fuel Suction with Pump and Gauge Tube Assembly | *4 | Fuel Pressure Regulator Assembly |
| *5 | Fuel Tank Assembly | *6 | Fuel Pump |
| *7 | Fuel Suction Filter | - | - |
| *a | Return | *b | The illustrations shown are examples only. |
CONSTRUCTION
Fuel Tank Assembly
A multiple layer plastic fuel tank assembly is used. This fuel tank assembly consists of 6 layers of 4 types of materials.
A fuel drain mark has been provided at the lowest position of the fuel tank assembly. When dismantling (scrapping) the vehicle, drain fuel by drilling a hole at the drain mark.
| *a | Fuel Tank Wall Cross Section | *b | High Density Polyethylene (HDPE) |
| *c | Regrind Material | *d | Adhesive |
| *e | Ethylene Vinyl Alcohol Copolymer (EVOH) | *f | Fuel Drain Mark |
| *g | View from Bottom Side | *h | The illustrations shown are examples only. |
|
Fuel Tank Assembly Outside |
|
Fuel Tank Assembly Inside |
Fuel Suction with Pump and Gauge Tube Assembly (Models without Canister Pump Module)
A fuel pump, fuel suction filter, fuel pressure regulator assembly and fuel sender gauge assembly with integrated fuel suction with pump and gauge tube assembly are used.
| *1 | Fuel Suction with Pump and Gauge Tube Assembly | *2 | Charcoal Canister |
| *3 | Fuel Pump | *4 | Fuel Suction Filter |
| *5 | Fuel Pressure Regulator Assembly | - | - |
Fuel Suction with Pump and Gauge Tube Assembly (Models with Canister Pump Module)
A compact fuel pump, fuel filter, fuel pressure regulator assembly and fuel sender gauge assembly are integrated into the fuel suction with pump and gauge tube assembly.
| *1 | Fuel Suction with Pump and Gauge Tube Assembly | *2 | Fuel Sender Gauge Assembly |
| *3 | Fuel Pump | *4 | Fuel Filter |
| *5 | Fuel Pressure Regulator Assembly | - | - |
| *a | Cross Section | - | - |
Fuel Delivery Pipe
A pressed steel fuel delivery pipe is used.
Pulsation that occurs when the fuel is fed is absorbed by the volume change caused by bending in the fuel delivery pipe. Therefore, the separately provided pulsation damper has been discontinued, reducing the size and weight.
| *1 | Fuel Delivery Pipe | *2 | Fuel Injector Assembly |
| *3 | Fuel Delivery Spacer | - | - |
Fuel Injector Assembly
12-holes type fuel injector assembly is used. It is possible to atomize fuel, which prevents the fuel from adhering to the intake port walls and reduces exhaust emissions.
| *1 | Injector Vibration Insulator | *2 | Fuel Injector Assembly |
| *3 | Fuel Injector O-ring | *4 | Filter |
| *a | View from A | - | - |