Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART ENTRY AND START SYSTEM › from 2017.06
NM2170E _58 Vehicle Interior _056985 THEFT DETERRENT / KEYLESS ENTRY _0277784 SMART ENTRY AND START SYSTEM UN GENERAL/CONTROL/DETAILS F

THEFT DETERRENT / KEYLESS ENTRY  SMART ENTRY AND START SYSTEM  GENERAL/CONTROL/DETAILS  GENERAL  


OUTLINE


a.

The smart entry and start system has the following main functions, making it a very user-friendly system.

Function Outline
Start Function

The start function is operated by simply pushing the power switch while carrying the electrical key transmitter sub-assembly. When the power switch is pushed, the certification ECU (smart key ECU assembly) turns the ACC relay, IG1 relay and IG2 relay on or off to switch the power source pattern.*

-

The power source pattern changes depending on depression of the brake pedal and the shift state.



Engine Immobiliser The engine immobiliser function compares the ID code that is registered in the ID code box (immobiliser code ECU) with the ID code of the transponder chip that is embedded in the electrical key transmitter sub-assembly.
Steering Wheel Lock The steering wheel lock function is operated to lock and unlock the steering wheel by using a lock/unlock mechanism in the steering column assembly.
Entry Function

The entry functions described below can be enabled while carrying the electrical key transmitter sub-assembly.

Entry Unlock:

All the doors and the back door unlock in the following situation:

-

Either of the front outside door handle is gripped.

-

The back door opener switch located on the back door opener switch assembly is pressed.


Entry Lock:

All the doors and the back door lock in the following situation:

-

The lock sensor on a front outside door handle is touched.

-

The back door lock switch located on the back door opener switch assembly is pressed.




HINT:

*: In this chapter, the expression "power source" has been used in some locations to allow precise explanations. The power source condition is also expressed using conventional expressions such as "power switch off", "power switch on (ACC)" and "power switch on (IG)".




PRECAUTION


a.

Door Control Receiver Expressions

i.

The type of door control receiver used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section.

Vehicle Specification Part Name in Manual Actual Part Name
Models with Tire Pressure Warning System Door Control Receiver Assembly Electrical Key and TPMS Receiver Assembly
Models without Tire Pressure Warning System Door Control Receiver Assembly Door Control Receiver Assembly