Home › General › INTRODUCTION › FEATURES › from 2017.06
NM2170E _V1 General _056956 INTRODUCTION _0277751 FEATURES UN GENERAL/CONTROL/DETAILS F

INTRODUCTION  FEATURES  GENERAL/CONTROL/DETAILS  PERFORMANCE  


OUTLINE


a.

TOYOTA Hybrid System-II (THS-II)

i.

This system optimally performs cooperative control of the 1NZ-FXE engine, and Motor Generator No. 1 (MG1) and Motor Generator No. 2 (MG2) in the P510 hybrid vehicle transaxle assembly that provides excellent transmission performance. Furthermore, this system uses a high-output HV battery with a nominal voltage of DC 144 V, and a variable-voltage system in which a boost converter boosts the operating voltage of the system to a maximum voltage of DC 520 V.

System Performance
Maximum System Output* kW 73.6

*: Maximum system output is engine output and MG2 output controlled by THS-II. MG2 output depends on power supplied by the HV battery.



b.

1NZ-FXE Engine

i.

The 1NZ-FXE is an in-line 4-cylinder, 1.5-liters, 16-valve DOHC engine.


ii.

This engine uses a high-expansion ratio Atkinson cycle, Variable Valve Timing-intelligent (VVT-i) system, Electric Throttle Control System-intelligent (ETCS-i) and Exhaust Gas Recirculation (EGR) system employing a highly efficient EGR cooler. In addition, use of an electric engine water pump assembly has eliminated the V-ribbed belt. Thus, improved engine performance, quietness, fuel economy, and cleaner emissions have been achieved.

Item Specification
No. of Cyls. & Arrangement 4-cylinder, In-line
Valve Mechanism 16-valve, DOHC with VVT-i
Fuel System SFI
Displacement cm3 (cu. in.) 1497 (91.3)
Max. Output (SAE-NET)* kW @ rpm 54 @ 4800
Max. Torque (SAE-NET)* N*m @ rpm 111 @ 3600 to 4400

*: Maximum output and torque rating are determined using the revised SAE J1349 procedure.




c.

P510 Hybrid Vehicle Transaxle Assembly

i.

The P510 hybrid vehicle transaxle assembly contains Motor Generator No. 1 (MG1) and Motor Generator No. 2 (MG2).

Item Specification
Motor Generator No. 1 (MG1) Motor Generator No. 2 (MG2)
Type Permanent Magnet Motor Permanent Magnet Motor
Function Generate, Engine Starter Generate, Drive Wheels
Cooling System Air-cooled Air-cooled
Maximum Output kW - 45
Maximum Torque N*m - 169



d.

Suspension

i.

A MacPherson strut type independent suspension is used for the front.


ii.

A torsion-beam type suspension is used for the rear.



e.

Steering

i.

An Electric Power Steering (EPS) system is used.



f.

Tire Pressure Warning System

i.

A direct-sensing type tire pressure warning system is used for some models.



g.

Brake

Item Specification
Front Brake Type Ventilated Disc
Rotor Size (D x T)* mm (in.) 255 x 22 (10.04 x 0.87)
Rear Brake Type Leading-trailing Drum
Drum Inner Diameter mm (in.) 228.6 (9.00)
Brake Control System ABS with EBD, Brake Assist, TRC, VSC, Hill-start Assist Control

*: Diameter x Thickness