FUNCTION OF MAIN COMPONENTS
| Component | Function |
|---|---|
| Vehicle Approaching Speaker Controller | Starts, stops and controls the output sound according to input signals from various ECUs. |
| Vehicle Approaching Speaker Assembly | Emits warning sounds based on the operation signal received from the vehicle approaching speaker controller. |
| Combination Meter Assembly
·
Multi-information Display |
Displays a warning message when there is a malfunction in the acoustic vehicle alerting system. |
| Hybrid Vehicle Control ECU | Sends the shift position signal and engine start/stop signal to the vehicle approaching speaker controller. |
| Brake Booster with Master Cylinder Assembly
·
Skid Control ECU |
Outputs a vehicle speed signal to the vehicle approaching speaker controller. |
OPERATING CONDITION
| Condition | Outline |
|---|---|
| System Active | The acoustic vehicle alerting system operates (emits a warning sound) when all of the following conditions are met:
·
Engine is stopped. ·
Vehicle speed is 25 km/h (16 mph) or less. ·
Shift position is any position other than P. ·
Vehicle speed exceeds 0 km/h (0 mph), front motor speed exceeds 32 rpm, or stop light switch is turned from on to off. |
| System Stopped | The acoustic vehicle alerting system stops operating when any of the following conditions are met:
·
The engine starts. ·
The vehicle speed is more than 25 km/h (16 mph). ·
Shift position is P. ·
With a vehicle speed of 0 km/h (0 mph) and a front motor speed of 32 rpm or less, the stop light switch is continuously on for approximately 0.24 seconds or more. ·
With a vehicle speed of 0 km/h (0 mph) and a front motor speed of 32 rpm or less, the stop light switch is continuously off for approximately 3 seconds or more.* |
*: When the system is stopped due to a vehicle speed of 0 km/h (0 mph), a front motor speed of 32 rpm or less and the stop lights being off for approximately 3 seconds or more, the system operates again when the vehicle speed is 1 km/h (1 mph) or more, the front motor speed is 33 rpm or more or the brake pedal is operated.
SYSTEM CONTROL
| Control | Outline |
|---|---|
| Vehicle Speed Linked Control | ·
Controls the volume and pitch of the output sound according to the received vehicle speed. ·
The warning sound becomes higher as the vehicle accelerates and it becomes lower as the vehicle decelerates. |
| Audibility Enhancing Control | When the acoustic vehicle alerting system is not sounding and the vehicle is stopped (vehicle speed of 0 km/h (0 mph)), if the system operates due to a vehicle speed signal or brake pedal operation (system is changed from being disabled to enabled), the warning sound volume becomes higher than usual for about 1 second to warn people around the vehicle that the vehicle may move. |
| Fade-in/Fade Out Control | When the system starts operating, the warning sound volume gradually increases, and when system operation is stopped, the sound volume gradually decreases. |
FUNCTION
Warning Indication
The combination meter assembly uses the multi-information display to notify the driver of acoustic vehicle alerting system malfunctions.
When the system is not available, the following warning occurs to warn the driver.
| Multi-information Display | Detail | Master Warning Light | Buzzer | DTC |
|---|---|---|---|---|
| ACOUSTIC VEHICLE ALERTING SYSTEM MALFUNCTION VISIT YOUR DEALER | This message appears when the vehicle approaching speaker controller detects a system malfunction | Illuminates | Sounds once | Repair is required, DTCs are stored |
DIAGNOSIS
The vehicle approaching speaker controller will also store Diagnostic Trouble Codes (DTCs). The DTCs can be read by using the Global TechStream (GTS). For details, refer to the Repair Manual.