Home › General › SPECIFICATIONS › P510 HYBRID TRANSMISSION / TRANSAXLE › 2011.12–2017.06
RM2170E _V1 General _057001 SPECIFICATIONS _0277864 P510 HYBRID TRANSMISSION / TRANSAXLE F

SPECIFICATIONS  P510 HYBRID TRANSMISSION / TRANSAXLE  SERVICE DATA  


Transaxle fluid pressure
Engine Speed Transaxle Fluid Temperature Transaxle Fluid Pressure
1000 rpm 20 to 50°C (68 to 122°F) 4.0 kPa (0.04 kgf/cm2, 0.6 psi) or more

Hybrid vehicle transaxle assembly type T oil seal LH side 2.5 to 3.5 mm (0.0984 to 0.138 in.)
RH side 3.0 to 4.0 mm (0.118 to 0.157 in.)
Input shaft type T oil seal 1.0 to 1.8 mm (0.0394 to 0.0709 in.)
Shift lever position sensor seal 5.5 to 6.4 mm (0.217 to 0.252 in.)

Shift lever assembly
Tester Connection Condition Specified Condition
4 (IG) - Body ground Power switch on (IG) 11 to 14 V
Power switch off Below 1 V
8 (STP) - Body ground Brake pedal depressed 11 to 14 V
Brake pedal released Below 1 V
7 (E) - Body ground Always Below 1 V
Tester Connection Shift Lever Position Specified Condition
4 (P) - 3 (E2) P 10 kΩ or higher
Other than P Below 1 V
Tester Connection Condition Specified Condition
1 (SLS+) - 2 (SLS-) Always 112 Ω
Shift lever position sensor
Tester Connection Shift Lever Position Specified Condition
7 (+B) - 1 (DB1) D or B Below 1 Ω
Except D or B 10 kΩ or higher
7 (+B) - 2 (N) N Below 1 Ω
Except N 10 kΩ or higher
7 (+B) - 3 (PR) P or R Below 1 Ω
Except P or R 10 kΩ or higher
7 (+B) - 4 (PNB) P, N or B Below 1 Ω
Except P, N or B 10 kΩ or higher
7 (+B) - 6 (DB2) D or B Below 1 Ω
Except D or B 10 kΩ or higher
7 (+B) - 8 (P) P Below 1 Ω
Except P 10 kΩ or higher
7 (+B) - 9 (R) R Below 1 Ω
Except R 10 kΩ or higher