Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277912 CAMSHAFT OIL CONTROL VALVE G

1NZ-FXE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.
A246904E01
0.14,0 0.438,0.272 0.297,0.272 10 *a

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.9 to 7.9 Ω

Text in Illustration
*a Component without harness connected
(Camshaft Timing Oil Control Valve Assembly)


If the result is not as specified, replace the oil control valve assembly.


b.

Check the operation.

i.
A160184E05
0.719,0.557 0.914,0.720 0.195,0.163 10 *1 0.719,1.681 0.874,1.844 0.155,0.163 10 *2

Connect a positive (+) auxiliary battery lead to terminal 1 and a negative (-) lead to terminal 2, and check the movement of the valve.

Text in Illustration
*1 When applied
*2 When cut off

NOTICE:

Confirm that the valve moves freely and does not stick in any position.


If necessary, replace the camshaft timing oil control valve assembly.

HINT:

Accumulation of foreign matter can cause minor pressure leaks. Minor pressure leaks will cause the camshaft to advance or retard, and this will cause a DTC to be set.