Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277912 CAMSHAFT OIL CONTROL VALVE G

1NZ-FXE ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 11101J 1.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

a.

Connect the intelligent tester to the DLC3.


b.

Turn the intelligent tester on.


c.

Set the vehicle to inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


d.

Start the engine.


e.

Inspect the oil control valve.

i.

Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the VVT System (Bank 1).


ii.

Check the engine speed when the oil control valve is operated using the intelligent tester with the engine coolant temperature at 50°C (122°F) or less.

HINT:
·

When performing the Active Test, the air conditioning should be on.

·

Engine coolant temperature when the engine is started should be 30°C (86°F) or less.



Standard:
Control Range Specified Condition
OFF Normal engine speed
ON Rough idle or engine stalls (soon after oil control valve switched from OFF to ON)