Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › THROTTLE BODY
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277913 THROTTLE BODY A

1NZ-FXE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 17705 2.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

a.
A267396

Disconnect the ventilation hose.


b.
A267397

Disconnect the purge VSV.


c.
A267398

Disconnect the mass air flow meter connector.


d.

Disconnect the wire harness clamp.


e.

Release the 2 clamps.


f.
A267400

Loosen the hose clamp and remove the air cleaner cap sub-assembly.


Hide 22030 3.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A267401

Disconnect the throttle body with motor connector and the 2 water by-pass hoses.


b.
A267402

Remove the 3 bolts.


c.

Remove the throttle body with motor assembly.


d.
A267403

Remove the gasket from the intake manifold.