Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › THROTTLE BODY
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277913 THROTTLE BODY G

1NZ-FXE ENGINE CONTROL  THROTTLE BODY  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 22030 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY

a.

Set the vehicle to inspection mode (See page General>INTRODUCTION>REPAIR INSTRUCTION>INSPECTION MODE PROCEDURE).


b.

Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.

Standard:
Condition Engine Idle Speed
A/C switched off 950 to 1050 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that park (P) is selected.