Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › MASS AIR FLOW METER
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277914 MASS AIR FLOW METER G

1NZ-FXE ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.
A190679E02
0.754,2.144 1.355,0.719 1.355,0.719 1.43,0.719 false 1.462,0.636 1.637,0.790 0.176,0.153 10 *1

Perform a visual check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter shown in the illustration.

Text in Illustration
*1 Platinum Hot Wire (Heater)

Result:

There is no foreign matter.


If the result is not as specified, replace the mass air flow meter.


b.
A190680E02
0.865,0.081 1.017,0.363 0.151,0.282 10 *1 2.281,0.828 2.587,1.011 0.306,0.183 10 THA 1.675,0.826 1.983,1.024 0.308,0.198 10 E2 2.928,1.46 2.721,0.904 2.721,0.904 2.657,0.904 false 2.771,1.467 2.012,0.906 2.012,0.906 1.925,0.906 false

Measure the resistance according to the value(s) in the table below.

Text in Illustration
*1 Mass Air Flow Meter

Standard Resistance:
Tester Connection Condition Specified Condition
1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ