Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › CAMSHAFT POSITION SENSOR
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277915 CAMSHAFT POSITION SENSOR A

1NZ-FXE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 11101E 1.REMOVE CAM POSITION SENSOR

a.
A267432

Disconnect the cam position sensor connector.


b.

Remove the bolt and cam position sensor.

NOTICE:

If the cam position sensor has been struck or dropped, replace it.



c.
A412347C01
1.781,1.885 1.781,1.563 false 1.729,1.896 2.042,2.052 0.313,0.156 10 false *1
*1 O-ring


Remove the O-ring from the cam position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the cam position sensor.

·

If the O-ring groove of the cam position sensor is damaged, replace the cam position sensor with a new one.