Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277916 CRANKSHAFT POSITION SENSOR G

1NZ-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  INSPECTION  


PROCEDURE

Hide 15100Q 1.INSPECT CRANK POSITION SENSOR

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 Cold 985 to 1600 Ω
Hot 1265 to 1890 Ω


HINT:

In the table above, the terms Cold and Hot refer to the temperature of the coils. Cold means approximately -10 to 50°C (14 to 122°F). Hot means approximately 50 to 100°C (122 to 212°F). If the resistance is not as specified, replace the camshaft position sensor.