Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › CRANKSHAFT POSITION SENSOR
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277916 CRANKSHAFT POSITION SENSOR A

1NZ-FXE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 15100Q 1.REMOVE CRANK POSITION SENSOR

a.
A087545

Disconnect the crank position sensor connector.


b.

Remove the bolt and crank position sensor.

NOTICE:

If the crank position sensor has been struck or dropped, replace it.



c.
A413178C02
1.656,1.896 1.656,1.469 false 1.656,4.01 1.656,3.583 false 0.208,0.292 0.542,0.573 0.333,0.281 12 false *A 0.229,2.375 0.656,2.75 0.427,0.375 12 false *B 1.594,1.917 1.906,2.073 0.313,0.156 10 false *1 1.594,4.01 1.906,4.167 0.313,0.156 10 false *1
*A for Type A
*B for Type B
*1 O-ring


Remove the O-ring from the crank position sensor.

NOTICE:
·

Make sure to only remove the O-ring with bare hands.

·

When removing the O-ring, be careful not to damage the O-ring groove of the crank position sensor.

·

If the O-ring groove of the crank position sensor is damaged, replace the crank position sensor with a new one.