Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG › 2011.12–2014.12
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277917 IGNITION COIL AND SPARK PLUG A

1NZ-FXE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  INSTALLATION  


PROCEDURE

Hide 19100P 1.INSTALL SPARK PLUG

a.

Using a 16 mm spark plug wrench, install the 4 spark plugs.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

If a component has been dropped or subjected a strong impact, replace it.


HINT:

Perform "Inspection After Repairs" after replacing the spark plug (See page Engine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION).



Hide 19500D 2.INSTALL NO. 1 IGNITION COIL

a.
A268161E01
2.268,1.59 2.463,1.785 0.195,0.195 10 *2 2.268,0.696 2.463,0.891 0.195,0.195 10 *1

Install the 4 No. 1 ignition coils with the 4 bolts.

Text in Illustration
*a Body
*b Cap

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:

If the body or cap of the No. 1 ignition coil is dropped or subjected to a strong impact, replace the No. 1 ignition coil with a new one.


HINT:

Perform "Inspection After Repairs" after replacing the ignition coil assembly (See page Engine / Hybrid System>1NZ-FXE (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>INITIALIZATION).



b.

Connect the 4 No. 1 ignition coil connectors.