Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › IGNITION COIL AND SPARK PLUG › from 2014.12
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277917 IGNITION COIL AND SPARK PLUG A

1NZ-FXE ENGINE CONTROL  IGNITION COIL AND SPARK PLUG  REMOVAL  


PROCEDURE

Hide 19500D 1.REMOVE NO. 1 IGNITION COIL

a.
A267419

Disconnect the 4 No. 1 ignition coil connectors.


b.

Remove the 4 bolts and 4 No. 1 ignition coils.

NOTICE:

When removing each ignition coil, do not damage the plug cap on the engine head cover opening or the upper edge of the spark plug tube.



Hide 19500F 2.REMOVE PLUG CAP

HINT:
·

Only perform this procedure when replacement of the plug cap is necessary.

·

If the plug cap has any damage, replace it with a new one.



a.

Remove the plug cap from the No. 1 ignition coil.

A326009E03
3.042,1.01 2.427,1.01 false 3.51,3.167 3.958,3.167 false 1.479,2.813 1.625,3.115 1.625,3.115 1.854,3.115 false 3.073,2.198 2.896,1.948 2.896,1.948 2.677,1.948 false 2.24,0.906 2.563,1.229 0.323,0.323 10 false *1 4.01,3.073 4.333,3.396 0.323,0.323 10 false *2 6.469,0.823 6.792,1.146 0.323,0.323 10 false *a 1.875,3.031 2.198,3.354 0.323,0.323 10 false *b 2.51,1.844 2.833,2.167 0.323,0.323 10 false *c

Text in Illustration
*1 No. 1 Ignition Coil *2 Plug Cap
*a Section (A) *b Spring
*c Plug Cap Fitting - -

NOTICE:
·

When removing the plug cap, make sure not to damage the plug cap fitting of the No. 1 ignition coil.

·

When removing the plug cap, do not deform the spring of the No. 1 ignition coil or allow it to fall out.

·

If the plug cap fitting has any damage, replace the No. 1 ignition coil with a new one.

·

If the spring is deformed or falls out, replace the No. 1 ignition coil with a new one. (The spring cannot be reassembled.)



HINT:

Spread section (A) of the plug cap and pull downwards to remove the plug cap.



Hide 19100P 3.REMOVE SPARK PLUG

a.
A267420

Using a 16 mm spark plug wrench, remove the 4 spark plugs.