Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277918 ENGINE COOLANT TEMPERATURE SENSOR G

1NZ-FXE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSPECTION  


PROCEDURE

Hide 89422 1.INSPECT ENGINE COOLANT TEMPERATURE SENSOR

A183498E06
0.221,0.774 0.455,0.932 0.234,0.158 10 kΩ 2.76,4.024 3.002,4.210 0.242,0.185 10 °C 2.737,4.21 3.024,4.406 0.287,0.196 10 (°F)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Condition Specified Condition
Approximately 20°C (68°F) 2.32 to 2.59 kΩ
Approximately 80°C (176°F) 0.310 to 0.326 kΩ


NOTICE:

When checking the engine coolant temperature sensor in water, keep the terminals dry. After the check, dry the sensor.


If the resistance is not as specified, replace the engine coolant temperature sensor.