Home › Engine / Hybrid System › 1NZ-FXE (ENGINE CONTROL) › HEATED OXYGEN SENSOR
RM2170E _51 Engine / Hybrid System _057003 1NZ-FXE ENGINE CONTROL _0277921 HEATED OXYGEN SENSOR G

1NZ-FXE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSPECTION  


PROCEDURE

Hide 89465 1.INSPECT HEATED OXYGEN SENSOR

U183317E02
1.427,1.25 0.958,0.927 0.958,0.927 0.813,0.927 false 1.385,1.708 0.979,1.854 0.979,1.854 0.823,1.854 false 2.01,1.26 2.313,0.958 2.313,0.958 2.469,0.958 false 1.615,0.323 1.792,0.5 0.177,0.177 10 false *a 0.573,0.844 0.771,1.135 0.198,0.292 10 false +B 0.656,1.375 0.958,1.667 0.302,0.292 10 false C16 0.604,1.771 0.802,2.063 0.198,0.292 10 false E2 2.51,0.885 2.906,1.177 0.396,0.292 10 false HT1B

Text in Illustration
*a Component without harness connected
(Heated Oxygen Sensor)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C16-1 (HT1B) - C16-2 (+B) 20°C (68°F) 11 to 16 Ω
C16-1 (HT1B) - C16-4 (E2) - 10 kΩ or higher


If the result is not as specified, replace the heated oxygen sensor.