Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › 2011.12–2014.12
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277924 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0A0F-204  Engine Failed to Start  P0A0F-205  Engine Failed to Start  P0A0F-206  Engine Failed to Start  P0A0F-524  Engine Failed to Start  P0A0F-525  Engine Failed to Start  


DESCRIPTION

If an engine malfunction occurs, an engine malfunction signal is sent from the ECM to the power management control ECU. When the power management control ECU receives this signal, it sets a DTC and performs fail-safe control.

DTC No. INF Code DTC Detection Condition Trouble Area
P0A0F 204 Signal indicating abnormality input from the ECM (abnormal engine output) SFI system
205 Signal indicating abnormality input from the ECM (engine is unable to start)
206 Signal indicating abnormality input from the ECM (engine component malfunction)
524 Signal indicating abnormality input from the ECM (NE signal error)
525 Signal indicating abnormality input from the ECM (GI signal error)

HINT:
·

The power management control ECU stores DTC P0A0F-204, 205, 206, 524 or 525 when it receives a signal from the ECM indicating abnormal engine power, engine starting malfunction, engine performance deterioration (running out of fuel), crank angle sensor circuit DTCs or cam position sensor circuit DTCs.

·

If the engine cannot start, the vehicle is driven using EV drive mode. However, if the vehicle is continuously driven using only EV drive mode, the HV battery will be discharged and the vehicle will not be able to be driven.

·

If any of these DTCs are output, it is required to repair the EFI system in accordance with the DTC or to add a sufficient amount of fuel.



CAUTION / NOTICE / HINT

HINT:
·

When SFI system related DTCs are output, the power management control ECU stores DTCs P0A0F-204, 205, 206, 524 or 525.

·

If SFI system related DTCs are stored, the MIL will illuminate.



PROCEDURE

1.CHECK DTC OUTPUT (ENGINE AND ECT)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Engine and ECT / DTC.


d.

Check if DTCs are output.


e.

Turn the power switch off.



NEXT