Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › 2011.12–2014.12
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277924 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0A94-590  DC / DC Converter Performance  


DESCRIPTION

Refer to the description for DTC P0A94-589 (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>P0A94-589).

DTC No. INF Code DTC Detection Condition Trouble Area
P0A94 590 Open or short to +B in the boost converter voltage (VL) sensor circuit Inverter with converter assembly

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the power switch on (IG) and wait for 5 seconds or more.



PROCEDURE

1.REFER TO REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS

(See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR)

HINT:

The boost converter voltage (VL) sensor is connected to the MG ECU inside the inverter with converter assembly.



NEXT

COMPLETED