Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277924 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0AEF-275  Drive Motor Inverter Temperature Sensor "A" Circuit Low  P0AF0-274  Drive Motor Inverter Temperature Sensor "A" Circuit High  


DESCRIPTION

The MG ECU located in the inverter with converter assembly detects the temperature of the motor inverter using a temperature sensor built into the inverter with converter assembly. The inverter cooling system operates independently of the engine cooling system. The MG ECU uses signals from the motor inverter temperature sensor to check the effectiveness of the inverter cooling system. If necessary, the MG ECU will limit inverter output to help prevent inverter overheating. The MG ECU also detects malfunctions in the motor inverter temperature sensor and its wiring.


DTC No. INF Code DTC Detection Condition Trouble Area
P0AEF 275 Open or short to GND in the motor inverter temperature sensor circuit Inverter with converter assembly
P0AF0 274 Short to +B in motor inverter temperature sensor circuit

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the power switch on (IG) and wait for 5 seconds or more.



PROCEDURE

1.REFER TO REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS

NEXT

COMPLETED