Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277924 HYBRID CONTROL SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  P0BCE-313  Generator Inverter Temperature Sensor Circuit Low  P0BCF-312  Generator Inverter Temperature Sensor Circuit High  


DESCRIPTION

The MG ECU located in the inverter with converter assembly detects the temperature of the generator inverter using the temperature sensor built into the inverter with converter assembly. The inverter cooling system operates independently of the engine cooling system. The MG ECU uses signals from the generator inverter temperature sensor to check the effectiveness of the inverter cooling system. If necessary, the MG ECU will limit inverter output to help prevent inverter overheating. The ECU also detects malfunctions in the generator inverter temperature sensor and its wiring.


DTC No. INF Code DTC Detection Condition Trouble Area
P0BCE 313 Open or short to GND in the generator inverter temperature sensor signal circuit Inverter with converter assembly
P0BCF 312 Short to +B in the generator inverter temperature sensor signal circuit

CAUTION / NOTICE / HINT

HINT:

After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

1.

Turn the power switch on (IG) and wait for 5 seconds or more.



PROCEDURE

1.REFER TO REPLACE INVERTER WITH CONVERTER ASSEMBLY PARTS

NEXT

COMPLETED