The power management control ECU receives a signal that indicates a collision from the airbag sensor assembly to detect a collision. After detecting a collision, the power management control ECU shuts off the high voltage systems for safety.
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P1606 | 308 | Shutoff signal from the airbag sensor assembly is determined. | ·
Airbag sensor assembly ·
Power management control ECU ·
Supplemental restraint systems |
| 317 | A collision is determined due to a wiring malfunction. | ·
Power management control ECU ·
Supplemental restraint systems |
If P1606-308 or 317 is output, the vehicle cannot start unless the DTCs are cleared using the intelligent tester.
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Turn the power switch on (IG) and wait for 5 seconds or more.
Check the vehicle condition.
| Result | Proceed to |
|---|---|
| The vehicle is not damaged. | A |
| The vehicle is damaged. | B |
A
B
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| P1606 only is output. | A |
| P0A1D is output. | B |
Turn the power switch off.
A
B
(See pageEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
Troubleshoot the airbag system (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
| Result | Proceed to |
|---|---|
| The system is normal. | A |
| There is a malfunction in the system. | B |
A
B
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Access the freeze frame data of DTC P1606 and read the INF code.
| Result | Proceed to |
|---|---|
| INF code 308 is output. | A |
| INF code 317 is output. | B |
Turn the power switch off.
A
B
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| One or two of the following conditions are met. | A |
| All of the following conditions are met. | B |
| DTC Output Status |
|---|
| DTC P3107-213 or P3107-214 is output. |
| DTC U0151-763 is output. |
| DTC U0110-160 or U0110-657 is output. |
Turn the power switch off.
A
B
(See pageEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)