Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID CONTROL SYSTEM › 2015.11–2017.06
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277924 HYBRID CONTROL SYSTEM D

HYBRID / BATTERY CONTROL  HYBRID CONTROL SYSTEM  VEHICLE CONTROL HISTORY  


VEHICLE CONTROL HISTORY (HYBRID CONTROL SYSTEM)


a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / Utility / Vehicle Control History.

GTS Display Measurement Item Note
Battery Smart Unit Mismatch Displays if the wrong type of battery voltage sensor is installed. -
Hybrid Battery Cooling Fan Performance Decrement History of "MAINTENANCE REQUIRED FOR HYBRID BATTERY COOLING PARTS AT YOUR DEALER" being displayed on the multi-information display. If "MAINTENANCE REQUIRED FOR HYBRID BATTERY COOLING PARTS AT YOUR DEALER" is displayed on the multi-information display, perform the following procedures.
·

Make sure the air intake port is not blocked.

·

Make sure there are no gaps between the connecting parts of the ducts.

·

Clean the No. 1 hybrid battery intake filter. Check for entry of foreign matter.


Afterwards, clear the DTCs to reset the learning values even if no DTCs are stored.



VEHICLE CONTROL HISTORY (AIRBAG SYSTEM)


HINT:

A part of the control history can be confirmed using the vehicle control history (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>VEHICLE CONTROL HISTORY).