Refer to the Description for DTC P0ABF-123 (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>P0ABF-123).
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| P0AC0 | 123 | When the battery current sensor is abnormal (1 or 2 trip detection) | ·
Hybrid battery junction block assembly ·
Battery smart unit |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Hybrid Control / DTC.
Read output DTCs (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| Only DTC P0AC0-123 is output or DTC P0AC0-123 and DTCs other than those in the following table are output. | A |
| Any of the DTCs in the following table are output at the same time. | B |
| DTC No. | Relevant Diagnosis |
|---|---|
| P0A95-123 | High Voltage Fuse |
| P0ABF-123 | Hybrid Battery Pack Current Sensor Circuit |
| P0AC1-123 | Hybrid Battery Pack Current Sensor Circuit Low |
| P0AC2-123 | Hybrid Battery Pack Current Sensor Circuit High |
| P0AFC-123 | Hybrid Battery Pack Sensor Module |
| P0B3D-123, P0B42-123, P0B47-123, P0B4C-123, P0B51-123, P0B56-123, P0B5B-123, P0B60-123, P0B65-123, P0B6A-123, P0B6F-123 | Hybrid Battery Voltage Sensor "A - K" Circuit Low |
Turn the power switch off.
Disconnect the intelligent tester from the DLC3.
A
B
(See pageEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>DIAGNOSTIC TROUBLE CODE CHART)
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Do not turn the power switch on (READY).
Enter the following menus: Powertrain / Hybrid Control / Data List / Battery block Vol -V01 to V10.
Select "Battery block Vol -V01 to V10" only. (Do not select any other Data List items.)
Check the voltage of each "Battery block Vol" of "Battery block Vol -V01 to V10" in the Data List with the power switch on (IG).
Any "Battery block Vol" changes by 0.3 V or more, 60 seconds after the power switch is turned on (IG). (the difference between the maximum and minimum voltage is 0.3 V or more.)
| Result | Proceed to |
|---|---|
| The change in voltage of any "Battery block Vol" is 0.3 V or more. | A |
| Other than above. | B |
A
B