Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › HYBRID BATTERY SYSTEM › 2011.12–2014.12
RM2170E _51 Engine / Hybrid System _057004 HYBRID / BATTERY CONTROL _0277925 HYBRID BATTERY SYSTEM C

HYBRID / BATTERY CONTROL  HYBRID BATTERY SYSTEM  P3011-123  Battery Block 1 Becomes Weak  P3012-123  Battery Block 2 Becomes Weak  P3013-123  Battery Block 3 Becomes Weak  P3014-123  Battery Block 4 Becomes Weak  P3015-123  Battery Block 5 Becomes Weak  P3016-123  Battery Block 6 Becomes Weak  P3017-123  Battery Block 7 Becomes Weak  P3018-123  Battery Block 8 Becomes Weak  P3019-123  Battery Block 9 Becomes Weak  P3020-123  Battery Block 10 Becomes Weak  


DESCRIPTION

Refer to the Description for DTC P0A80-123 (See page Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID BATTERY SYSTEM>P0A80-123).


DTC No. INF Code DTC Detection Condition Trouble Area
P3011
P3012
P3013
P3014
123 Presence of a malfunctioning block is determined based on each battery block voltage (1 trip detection).
·

HV battery

·

Battery smart unit


P3015 123 Presence of a malfunctioning block is determined based on each battery block voltage (1 trip detection).
·

HV battery

·

Battery smart unit

·

Service plug grip


P3016
P3017
P3018
P3019
P3020
123 Presence of a malfunctioning block is determined based on each battery block voltage (1 trip detection).
·

HV battery

·

Battery smart unit



HINT:
·

P3011-123 to P3019-123 and P3020-123 will not be set unless the vehicle is driven for approximately 10 minutes after clearing the DTCs.

·

In order to ensure HV battery performance, appropriate cooling performance must be maintained. Perform the following as necessary:

-

Make sure the air intake port is not blocked.

-

Clean the battery cooling blower filter.




CAUTION / NOTICE / HINT

CAUTION:

When disposing of an HV battery, make sure to return it through an authorized collection agent who is capable of handling it safely. If the HV battery is returned via the manufacturer specified route, it will be returned properly and in a safe manner by an authorized collection agent.


PROCEDURE

1.CHECK DTC OUTPUT (HYBRID CONTROL)

A

2.READ VALUE USING INTELLIGENT TESTER (VB1 - VB10)

B

2.READ VALUE USING INTELLIGENT TESTER (VB1 - VB10)

A

B

3.CHECK DTC OUTPUT (HYBRID CONTROL)
3.CHECK DTC OUTPUT (HYBRID CONTROL)
a.

Connect the intelligent tester to the DLC3.


b.

Turn the power switch on (IG).


c.

Enter the following menus: Powertrain / Hybrid Control / DTC.


d.

Check if DTCs are output.

Result
Result Proceed to
P3015-123 is output. A
P3015-123 is not output. B

HINT:

DTC P3015-123 may also stored if there is foreign matter, etc. adhering to the connecting part of the service grip.



e.

Turn the power switch off.



A

REPLACE SERVICE PLUG GRIP AND HV BATTERY

B