15100C
1.INSTALL OIL PUMP SEAL
Apply MP grease to the lip of a new oil pump seal.
Keep the lip free from foreign matter.
Using SST and a hammer, tap in the oil pump seal until its surface is flush with the front oil pump seal retainer edge.
0 to 1.0 mm from the edge of the timing chain cover.
Do not tap the oil pump seal at an angle.
Wipe off extra grease from the crankshaft.
13407
2.INSTALL CRANKSHAFT DAMPER SUB-ASSEMBLY
Align the hole of the crankshaft damper sub-assembly with the straight pin, then install the crankshaft damper sub-assembly.
Using SST, hold the crankshaft damper sub-assembly in place and tighten the bolt.
| *a | Hold |
|
Turn |
When installing SST, be careful that the bolt which holds SST does not interfere with the timing chain cover.
12305
3.INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
Temporarily install the engine mounting insulator sub-assembly RH with the 4 bolts and 2 nuts.
Tighten the 3 bolts (A) in the sequence shown in the illustration.
Tighten the bolt (B) and 2 nuts.
4.INSTALL NO. 2 ENGINE ROOM RELAY BLOCK AND NO. 2 JUNCTION BLOCK ASSEMBLY
Install the No. 2 engine room relay block and No. 2 junction block assembly with the 2 nuts and bolt.
5.INSPECT FOR OIL LEAK
51441C
6.INSTALL ENGINE UNDER COVER RH
7.INSTALL FRONT WHEEL RH