Home › Engine / Hybrid System › 1NZ-FXE (ENGINE MECHANICAL) › CYLINDER HEAD
RM2170E _51 Engine / Hybrid System _057005 1NZ-FXE ENGINE MECHANICAL _0277950 CYLINDER HEAD A

1NZ-FXE ENGINE MECHANICAL  CYLINDER HEAD  DISASSEMBLY  


PROCEDURE

Hide 11117A 1.REMOVE TAPER SCREW PLUG

a.
U158826

Using a 10 mm hexagon wrench, remove the taper screw plug and gasket.

HINT:

If water leaks from the taper screw plug or the plug is corroded, replace it.



Hide 15678A 2.REMOVE OIL CONTROL VALVE FILTER

a.
U158822

Using an 8 mm hexagon wrench, remove the straight screw plug.

HINT:

If water leaks from the straight screw plug or the plug is corroded, replace it.



b.

Remove the oil control valve filter and gasket.


Hide 13751 3.REMOVE VALVE LIFTER

a.
U158827

Remove the 16 valve lifters.

HINT:

Arrange the valve lifters in the correct order.



Hide 13711 4.REMOVE INTAKE VALVE

a.
A265772E01
2.727,0.142 3.025,0.298 0.299,0.155 10 SST 1.846,0.766 2.387,0.226 2.387,0.226 2.698,0.226 false

Using SST and wooden blocks, remove the 16 retainer locks.

SST
09202-70020  (09202-00010, 09202-01010, 09202-01020)

HINT:

Arrange the removed parts in the correct order.



b.

Remove the 8 retainers, 8 compression springs and 8 intake valves.

HINT:

Arrange the removed parts in the correct order.



Hide 13715 5.REMOVE EXHAUST VALVE

a.
A265773E01
2.411,0.522 2.734,0.686 0.323,0.164 10 SST 1.822,0.612 2.391,0.612 false

Using SST and wooden blocks, remove the 16 retainer locks.

SST
09202-70020  (09202-00010, 09202-01010, 09202-01020)

HINT:

Arrange the removed parts in the correct order.



b.

Remove the 8 retainers, 8 compression springs and 8 exhaust valves.

HINT:

Arrange the removed parts in the correct order.



Hide 6.REMOVE VALVE STEM OIL SEAL

a.
A080961

Using needle-nose pliers, remove the 16 valve stem oil seals.


Hide 13734 7.REMOVE VALVE SPRING SEAT

a.
A080962

Using compressed air and a Magnet Hand, remove the 16 valve spring seats by blowing air onto them.